Cabletron Systems SmartSwitch 9W006 User Manual page 167

S M
YSTEM ESSAGES
System Message Summary
X25 facilities warning, transit delay not available
The service provider does provide transit delay information. No action required.
X25 facilities warning, charge inform not available
The service provider does provide charging information. No action required.
X25 facilities warning, call redirect notification not available
The service provider does provide call redirect information. No action required.
X25 facilities warning, NUI not available
Network device identification not available. No action required.
X25 permanent virtual circuit down: Access=<access index>, PVC=<PVC index>, LCN=<LCN>
The indicated X.25 virtual circuit is down. Switched backup connections will be used, if available.
This message will occur if the other system is down, or if the network interface line is not connected,
or if the authentication of the remote device failed.
X25 permanent virtual circuit to device <device name> up: Access=<access index>, PVC=<PVC index>,
LCN=<LCN>
The indicated X.25 virtual circuit is operational.
XMODEM DATA FAILED CRC CHECKS
A file contained in the X-Modem file set has failed the CRC check. The system will automatically
reset and attempt a reboot in an effort to correct the problem. If the system continues to fail, make
note of the displayed messages, and call your distributor. A software update is likely needed.
Zone allocation failed, increase zone table capacity.
The number of AppleTalk zones has surpassed the configured zone table capacity. The
SmartSwitch Remote Access Module configuration utility allows you to set the maximum number
of defined and learned zone table entries. The default value is 512. The maximum is 2,000. You may
need to reset the zone table capacity to a higher number.
Zone allocation failed, maximum capacity already configured
The maximum number of AppleTalk zones have been surpassed. Contact your Distributor or
Customer Support.
9W006 and 9W007 167