Cabletron Systems SmartSwitch 9W006 User Manual page 113

[AUTH] ACE Client has not been initialized.
The ACE client has not been initialized. No service file exists. Server should be expecting
SmartSwitch Remote Access Module client to request node verification. Contact the ACE
administrator and request the client to be reinitialized.
[AUTH] ACE Could not create service file.
The SmartSwitch Remote Access Module ACE client was in an initialized state. After receiving
service information from the ACE server a local file create error occurred while attempting to save
the information.
[AUTH] ACE Could not synchronize client-server.
During an authentication attempt the client was unable to synchronize with the server and the user
was rejected. The server may not be responding to the client.
[AUTH] ACE Could not write service file.
The SmartSwitch Remote Access Module ACE client was in an initialized state. After receiving
service information from the ACE server a local file write error occurred while attempting to save
the information.
[AUTH] ACE Decryption of server response failed.
Sever response to an ACE client request was received, but could not be decrypted. Verify
encryption method configured for server is accurate.
[AUTH] ACE Encryption configured for DES: not supported.
The ACE server is configured for DES encryption. Only SDI encryption is currently supported by
the ACE client.
[AUTH] ACE Error receiving server log message acknowledgment.
A client syntax error occurred during an authentication attempt via ACE. The server did not
respond to the logging of the message. Make sure the ACE server configuration is accurate.
[AUTH] ACE LOGIN rejected user: <user name>
The remote Authentication server rejected the named user. This indicates that one of the following
has occurred:
1. The <user name> is not in the remote Authentication server's database.
2. The <user name> is entered incorrectly in the remote Authentication server's database.
[AUTH] ACE Node verification received; Client initialized.
The SmartSwitch Remote Access Module ACE client was in an initialized state. Node verification
was received from the server and the initialization cycle is complete.
[AUTH] ACE No server configured for designated database location.
ACE is configured as a database location for security authentication. Either no ACE server has been
configured or an error occurred when parsing the ACE server configuration.
S M
YSTEM ESSAGES
System Message Summary
9W006 and 9W007 113