Installation; Connecting The Module's Cabling - Cabletron Systems SmartSwitch 9W006 User Manual

USER'S GUIDE
I
NSTALLATION
1. Note that the module is a double wide module and will fill two SmartSwitch 9000 slots.
Remove the SmartSwitch 9000's back panels that are covering the two slots into which the
module will be installed. To ensure proper airflow and cooling, all other empty slots must be
covered.
2. Before installing the SmartSwitch Remote Access Module into the chassis, ensure that the
bottom and top plastic tabs are unlocked.
3. Slide the module into the available slots making sure that the module is between the guides as
shown in the following illustration. Check both the upper and lower tracks. Take care that the
module slides in straight and engages the backplane connectors properly.
Metal Back Panel
4. Lock down the top and bottom plastic tabs at the same time, applying even pressure.
C
ONNECTING THE
Installing the module into the SmartSwitch 9000 automatically completes its power supply and
SMB connections. As you slide the module into place, the module's power supply and SMB
connectors slide into the SmartSwitch 9000's power supply and its SMB-1 BUS. What you will need
44 SmartSwitch Remote Access Module
MMAC PLUS
C a b l e t r o n
Systems
MMAC PLUS
M ' C
ODULE S ABLING
Ejector Tabs
1
2
1 2
3 4
Jack for ESD
Wrist Strap
Circuit Card
Card Guides