Snmp - Cabletron Systems SmartSwitch 9W006 User Manual

need to examine the segment's configuration to check the actual AppleTalk address (using
steps i through m below). If the value selected is unnumbered, continue with step n.
j. From the toolbar, select Functions, click AppleTalk Network, then Systems, or click
the toolbar.
k. Double click on the system in question.
l. Click on the Ports tab.
m. Double click on the WAN segment identified in step i above.
n. Verify the information entered for the Network Number and Node ID. These values make up
the AppleTalk address. Make any necessary changes.
o. If you made any changes, download the new configuration files to the site.
For more detailed instructions, refer to the following sections in the SFVRA Configuration
Manager User's Guide:
• For AppleTalk configuration group information: refer to Adjusting Protocol Information in
the Configuring Connection Groups chapter.
• For AppleTalk address information: refer to Configuring AppleTalk Network System Ports in
the Configuring AppleTalk Network Information chapter.
• For downloading updated configuration files: refer to Downloading Configuration Updates in
the Exporting Configuration Files chapter.
4. If the remote resources can not be seen even when the connection is up, then make sure the
AppleTalk address of the remote device is valid. If the remote device is on an unnumbered
network, then AppleTalk an address of 0.0 must be configured for the remote device. If it is on
a numbered network, the AppleTalk address does not need to be configured for the device.
However, if it is configured, it must match the AppleTalk address configured on the remote
device.

SNMP

Problem:
The SNMP Agent is not functioning.
Action:
1. Using SFVRA-CFG, check the configuration of the SmartSwitch Remote Access Module. In
order for the SNMP Agent to become enabled, both the IP option and the SNMP Agent must
be enabled in the SmartSwitch Remote Access Module configuration. The site must be
configured in an SNMP Management Group.
a. If it is not already running, start up SFVRA-CFG.
b. To see if IP is enabled for the system:
• From the toolbar, select Functions then select Sites or click the
P D
ROBLEM IAGNOSIS
SNMP
icon.
9W006 and 9W007 101
on