Saving Dynamic Management Changes - Cabletron Systems SmartSwitch 9W006 User Manual

cls
Clears the display screen. This command is also available as an administration command.
help
The Manage Mode help command lists the available Dynamic Management commands and
instructs the user to enter the command followed by a question mark to see help information
for that specific command.
readme
Displays helpful tips on how to use the Dynamic Management commands.
S D M
AVING YNAMIC ANAGEMENT
The Dynamic Management commands allow system data to be changed in real-time. These
changes take effect immediately upon the execution of the command and remain in effect until the
system is restarted. Once a software restart occurs, the changes are lost because the software reads
its initial system data values from a series of configuration files.
To prevent desired data changes from being overwritten by the restart process, the commit
command should be executed. This command writes the current system data to the appropriate
disk files, thus making all changes permanent, even if the system software is restarted.
The commit status command displays the number of dynamic changes that have been made
using each Dynamic Management command since the last commit was performed.
To return to the normal operating mode after you have committed your changes, issue the
following command:
MANAGE> exit
C
HANGES
C O
ONFIGURATION VERVIEW
Dynamic Management
9W006 and 9W007 39