Cabletron Systems SmartSwitch 9W006 User Manual page 161

S M
YSTEM ESSAGES
System Message Summary
[TFTP] Unable to open Server UDP port (69)
The TFTP Server was not initialized; however, the TFTP Client may still work. If this message
occurs repeatedly, or if the TFTP Client does not work, contact your Distributor or Customer
Support.
The call deflection selection is prior to CCITT 1988
Verify that the facilities provided by the service provider are CCITT 1988.
The call has been disconnected
A call has been up longer than the amount of time configured and has been taken down.
The call is allowed to continue
A call has been up longer than the amount of time configured, but it has not been taken down.
The compression subsystem is not enabled
Check SFVRA-CFG; verify that compression is enabled.
The conformance selection is prior to CCITT 1988
Verify that the facilities provided by the service provider are CCITT 1988.
The RADIAC Feature is no longer supported. The RADIAC feature has been replaced by the TACACS
Feature. The TACACS Feature configuration must be completed before usage.
With the addition of User Level Security, the need for the RADIAC GATEWAY is gone. The
SmartSwitch Remote Access Module has incorporated the functionality of the RADIAC
GATEWAY within the SmartSwitch Remote Access Module itself. When the configuration file
parser encounters a system configured for using the RADIAC feature, it switches the configuration
to now use User Level Security utilizing a TACACS off-node authentication server. Since the older
SmartSwitch Remote Access Module knew nothing about the location of the TACACS server, the
TACACS server configuration must be completed before the SmartSwitch Remote Access Module
will allow network access through a WAN connection.
Timeout detected on connection establishment
The system initiated a connection with a remote site, but a time-out occurred while waiting for a
connection response from the network. Verify that the remote site is active and that the network is
operational.
Timeout detected on receiving caller's number
The incoming call security feature is enabled and the caller's number was not received, so the call
was disconnected. Contact your phone company and verify that your switch supports passing
along the calling number information element. (This is sometimes referred to as ICLID for
InComing Line Identification).
Timeout on SPID Exchange - Slot=<slot# > Port=<port # > Ces=<communication endpoint suffix>
SPID exchange was not completed in time (i.e., switch never responded to the SPID). Check switch
configuration to make sure the correct SPID value has been entered.
Timeout on Startup Complete
A startup complete message was not return from the Combinet after we sent the response a number
of times. Check the configuration, and then reboot the Combinet. If problem persists, contact your
Distributor or Customer Support.
9W006 and 9W007 161