Verifying Ip Routing Over Awan Remote Lan Interface - Cabletron Systems SmartSwitch 9W006 User Manual

USER'S GUIDE
If the remote IP host CANNOT ping to the local IP host, refer to
Connection in the Problem Diagnosis chapter.
V IP R
ERIFYING OUTING
To verify that IP routing is properly operational over a WAN Remote LAN interface, a remote IP
Host must be operational and connected to the remote LAN. The remote bridge device must be
operational and available to initiate connections. Also, a local IP host must be connected to the local
LAN port on the SmartSwitch Remote Access Module.
Below is an example of a configuration used to verify IP routing over a WAN Remote LAN
interface. It uses IP addresses specific to the example. Substitute the IP addresses of your network
when you perform the IP routing verification steps. It also uses the "ping" command. The "ping"
command sends a packet to a specified host, waits for a response, and reports success or failure.
Substitute the equivalent command on your IP host.
100.0.0.0
The steps to verify the operation of IP routing over a WAN Remote LAN interface are:
1. Determine if a remote IP host can access the WAN Remote LAN interface of the SmartSwitch
Remote Access Module over the WAN connection. On the remote IP host type:
ping 192.100.1.1 <return>
If the remote IP host successfully pings to the SmartSwitch Remote Access Module, then
continue with the next step.
If the remote IP host CANNOT ping to the SmartSwitch Remote Access Module, refer to
Routing over a WAN Remote LAN Interface Connection
2. Determine if a remote IP host can access the LAN interface of the SmartSwitch Remote Access
Module over the WAN connection. On the remote IP host type:
ping 100.0.0.1 <return>
60 SmartSwitch Remote Access Module
O WAN R
VER A EMOTE
MMAC-Plus with
MMAC PLUS
C a b l e t r o n
Systems
Remote Access Module
100.0.0.1
Host A
100.0.0.2
IP Routing Over a WAN Interface
LAN I
NTERFACE
SmartSWITCH
192.100.1.1
ISDN
192.100.1.3
of the Problem Diagnosis chapter.
Bridge
Host B
IP