Cabletron Systems SmartSwitch 9W006 User Manual page 272

USER'S GUIDE
Command
telnet mode commands:
close
exit
open [target host][port # ]
send [send parameter]
set <name><value>
status
toggle
term
term set <terminal type>
tftp get
tftp put
tftp session
tftp session kill <session id>
tftp stats
time [hours:minutes:seconds]
trace [on/off]
trace ipxwan [on/off]
trace ppp [on/off]
udp conns
udp stats
ver
wan stats
wr
ws
272 SmartSwitch Remote Access Module
Use
closes the current Telnet connection to a target host
closes the current Telnet session
establishes a Telnet session with a target host
sends special Telnet control functions to the currently
connected target host
sets operating parameters for the current Telnet session
provides information about the current Telnet session
sets operating parameters for the current Telnet session
displays the terminal type.
sets the terminal type
invokes the TFTP GET command
invokes the TFTP PUT command
displays TFTP session statistics
terminates the active TFTP session specified by the session
id
(GUEST) displays the current TFTP statistics
displays or changes current system time
enabled or disables call trace information reports
enables or disables the IPXWAN tracing option
enables or disables the tracing of ppp packets
displays UDP connection status
displays UDP statistics
(GUEST) displays current software version and hardware resource
revision information
displays current WAN connection information
writes current system messages to disk
writes current system statistics to disk