Verifying Remote Device Connectivity; Verifying Ip Routing Over Interfaces; Verifying Ip Routing Over A Lan Interface - Cabletron Systems SmartSwitch 9W006 User Manual

Refer to Remote Device Connectivity
that use dedicated connections are PPP devices, follow the described set-up procedure, then
skip to the step specific for
V R
ERIFYING EMOTE
To verify remote device connectivity to the SmartSwitch Remote Access Module, the WAN lines
that are connected to the system must be available for use, and the bridging and/or routing options
must be properly initialized. The remote devices must be operational and available to initiate ISDN
WAN connections.
The method of connection initiation is dependent upon the remote device type. Refer to the remote
device documentation to determine how to initiate an ISDN WAN connection.
To verify remote device connectivity:
1. In a controlled manner, initiate an ISDN connection from each remote device.
2. When each remote device connects to the system, it will appear as either a "REMOTE site" or
as the configured Device Name (if security is enabled) on the Monitor Connections screen. To
display the Monitor Connections screen, enter the following console command:
mc <return>
Note: The terminal type must be the same for Telnet and the terminal emulation. Use the
term set
If each remote device is able to connect to the SmartSwitch Remote Access Module, then WAN
connectivity is successful.
If a remote device is NOT able to connect to the system, then refer to
in the Problem Diagnosis chapter.
V IP R
ERIFYING OUTING
The following sections provide a method of verifying that IP routing is operational over the
available interfaces.
V IP R
ERIFYING OUTING
To verify that IP routing is operating properly over the LAN connection, an IP host must be
connected to the local LAN port on the SmartSwitch Remote Access Module. The host must be
properly configured and operational on the IP network to which it is connected.
Below is an example of a configuration used to verify IP routing over a LAN connection. It uses IP
addresses specific to the example. Substitute the IP addresses of your network when you perform
the IP routing verification steps.
in the Problem Diagnosis chapter. Because all remote devices
PPP devices.
D C
EVICE ONNECTIVITY
administration console command to set the terminal type.
O I
VER NTERFACES
O LAN I
VER A NTERFACE
S
YSTEM

Verifying Remote Device Connectivity

Remote Device Connectivity
9W006 and 9W007
V
ERIFICATION
57