Appletalk Routing; Appletalk Routing Initialization - Cabletron Systems SmartSwitch 9W006 User Manual

USER'S GUIDE
Action:
1. Verify triggered RIP/SAP has successfully started for peers. Issue the dr console command
and look for the "starting" message in the log.
2. Generate a triggered RIP/SAP update request to the devices in question. Issue the following
console command for each device:
ipx trigreq <device>
3. Verify that the statistics are incremented properly. Issue the following console commands:
ipx trigrip stats
ipx trigsap stats
4. If routes/services are not propagated on either side, contact Customer Support.
A T R
PPLE ALK OUTING
This section provides methods for diagnosing problems in the following areas of AppleTalk
routing:
•

AppleTalk routing initialization

• AppleTalk routing over the LAN connection
• AppleTalk routing over the WAN connection
Use the following example configuration to diagnose AppleTalk routing operational problems. The
example below uses AppleTalk addresses, zones, and resource names specific to the example.
Substitute those of your network when you perform the diagnosis steps.
Net Range: 10-11
Zone: Left Zone
A T R
PPLE ALK OUTING
Problem:
The SmartSwitch Remote Access Module does not display the correct AppleTalk Routing
Initialization messages.
96 SmartSwitch Remote Access Module
MMAC-Plus with
SmartSWITCH
Remote Access Module
"Site 1"
MMAC PLUS
C a b l e t r o n
Systems
Local Mac
I
NITIALIZATION
ISDN
CSX1200
"Site2"
WORKGROUP REMOTE ACCESS SWITCH
LAN
POWER SERVICE TX RX 10BASE-T
Net Range: 20-21
Zone: Right Zone
Remote Mac
LINE LINE LINE LINE
1 2 3 4
CH-1 CH-2 CH-1 CH-2 CH-1 CH-2 CH-1 CH-2
SYNC D-CH SYNC D-CH SYNC D-CH SYNC D-CH
AGI