Cabletron Systems SmartSwitch 9W006 User Manual page 127

S M
YSTEM ESSAGES
System Message Summary
Downloading DM card in slot <slot # > with operational software
Informational message displayed during a successful initialization. Watch for subsequent log
messages to ensure the initialization is successful.
Downloading WAN card in slot <slot # > with operational software
Informational message during a successful system initialization. The status of the download
process for WAN card in slot <slot # > is identified. This should be reported after the "Bootstrap
came alive..." message for a given adapter.
DSL test failed to establish Layer 1, port=<port # >
During power up, all WAN lines undergo a test to see if Layer 1 can be established. This message
indicates a test failure. Check the wiring. If correct, contact your phone company.
Duplicate Calling Line ID <Calling line Id> detected for devices <device name> and <device name>
This message is logged at system initialization if any devices are found to share duplicate Calling
line Ids, and have no other authentication method. This problem should be corrected by adding
additional authentication method(s) to the necessary device(s).
Each mandatory connection uses xx bytes
There is not enough memory available to accommodate the system's total capacity load. This
informational message identifies how much memory is needed to add an additional mandatory
connection.
Each optional connection uses xx bytes
There is not enough memory available to accommodate the system's total capacity load. This
informational message identifies how much memory is needed to add an additional optional
connection.
ECP negotiation failed to converge
Verify compatible encryption parameters on each side of the link.
EDRV transmit error <error code>
An error was returned upon the software's request to transmit a data frame. Contact your
Distributor or Customer Support.
EDS-DES Board Absent
EDS-FEAL Board Absent
The encryption board is either physically not in the backplane, or the dip switches on the board are
set incorrectly. Check for the board; verify the switch settings.
Error closing file 's'
The WAN card initialization subsystem encountered an error while downloading a WAN card. The
system could not close the download disk file indicated. Restart the system. If the error continues,
Contact your Distributor or Customer Support.
Error closing file <file name>, slot <slot # >
Error closing password data file
If seen repeatedly, the above messages indicate a problem with your hard drive. Please contact
your Distributor or Customer Support.
9W006 and 9W007 127