Verifying Appletalk Routing Is Operational - Cabletron Systems SmartSwitch 9W006 User Manual

USER'S GUIDE
If these messages are NOT displayed, refer to
Diagnosis chapter.
V A T
ERIFYING PPLE ALK
To verify that AppleTalk routing is properly operational, a remote Macintosh must be operational
and available to initiate WAN connections via a remote AppleTalk router device. Also, a local
Macintosh device must be connected to the local LAN port on the SmartSwitch Remote Access
Module.
Below is an example of a configuration used to verify AppleTalk Routing operation. It uses
AppleTalk addresses, zones and resource names specific to the example. Substitute those of your
network when you perform the AppleTalk Routing feature verification steps.
Remote Access Module
Net Range: 10-11
Zone: Left Zone
70 SmartSwitch Remote Access Module
R O
OUTING IS PERATIONAL
MMAC-Plus with
SmartSWITCH
"Site 1"
MMAC PLUS
C a b l e t r o n
Systems
Local Mac
AppleTalk Routing Initialization
ISDN
CSX1200
"Site2"
LAN
POWER
SERVICE TX RX
Remote Mac
in the Problem
B-CHANNELS E1 ONLY
B1 B3 B5 B7 B9 B11 B13 B15 B17 B19 B21 B23 B25 B27 B29 B31
10BASE - T
E1 T1
B2 B4 B6 B8 B10 B12 B14 B16 D B18 B20 B22 B24 D B26 B28 B30 L1
Net Range: 20-21
Zone: Right Zone