Problem Diagnosis; Overview; Wan Adapter; Lan Adapter - Cabletron Systems SmartSwitch 9W006 User Manual

P D
ROBLEM IAGNOSIS
O
VERVIEW
This chapter, when used in conjunction with the
correct problems encountered in the verification process.
During some of the diagnosis procedures, we ask you to enter an administration console command.
To enter these commands, you must have an active administration session. If you need instructions
for starting an administration session, refer to
WAN A
DAPTER
Problem:
The system does not display the WAN Adapter Initialization messages. Instead, the system
displays one of the following messages:
Error mapping WAN adapter # into Host memory map
Type mismatch of configured & installed adapter #
Error initializing WAN card: #
Failure during static RAM test on adapter #
Error downloading operational software to adapter #
Error downloading bootstrap program to adapter #
Action:
1. Note the displayed error message. Restart the SmartSwitch Remote Access Module, and
recheck for one of the above error messages.
2. If the error message is still displayed, contact Customer Support.
LAN A
DAPTER
Problem:
The system does not display the LAN Adapter Initialization messages. Instead, the system displays
one of the following messages:
Invalid LAN Adapter identifier
LAN Adapter Command Timeout
LAN Adapter FIFO not empty, status = #
LAN Adapter LAN Controller error
LAN Adapter Response Timeout
MAC layer Bridge did not Initialize
[IP] Initialization failure
Action:
1. Note the displayed error message. Restart the SmartSwitch Remote Access Module, and
recheck for one of the above error messages.
2. If the error message is still displayed, contact your distributor for hardware replacement.
System Verification chapter, helps diagnose and
Accessing the SmartSwitch Remote Access Module.