Verifying Ipx Routing Is Operational; Verifying Ipx Routing Over A Lan Connection - Cabletron Systems SmartSwitch 9W006 User Manual

V IPX R
ERIFYING OUTING IS
To verify that IPX routing feature is properly operational, a local NetWare client, a local NetWare
server and a remote NetWare server must be operational.
The following graphic illustrates an example network we will use to describe how to verify that IPX
routing is operational. It uses IPX network addresses specific to the example. Substitute the IPX
network numbers of your network when you perform the verification steps. The example also uses
NetWare commands available for the Windows 95 workstation. Substitute the equivalent
commands on your NetWare client.
V IPX R
ERIFYING OUTING OVER A
To verify the operation of IPX Routing over a LAN connection:
1. Determine if SITE1 can access the local NetWare Server "local." On SITE1's administration
console type:
ipx diag cc:1 <return>
Note: Node address 1 is used by the NetWare servers as part of their internal address.
2. If the system displays a response to the ipx diag command similar to:
received 3 components from cc:1
then IPX routing over that LAN port is operational.
If this message IS NOT displayed, then IPX routing over the LAN connection is not operational.
Refer to IPX Routing over the LAN Connection
O
PERATIONAL
"SITE1"
MMAC PLUS
MMAC-Plus with
C a b l e t r o n
Systems
SmartSWITCH
Remote Access Module
Network AA
NetWare NetWare
Client A Server
"local"
Internal
Network CC
LAN C
ONNECTION

Verifying IPX Routing is Operational

ISDN
CSX1200
POWER
Internal
Network DD
in the Problem Diagnosis chapter.
S V
YSTEM ERIFICATION
"SITE2"
LAN B-CHANNELS E1 ONLY
B1 B3 B5 B7 B9 B11 B13 B15 B17 B19 B21 B23 B25 B27 B29 B31
SERVICE TX RX 10BASE - T
E1 D D T1
B2 B4 B6 B8 B10 B12 B14 B16 B18 B20 B22 B24 B26 B28 B30 L1
Network BB
NetWare
Server
"remote"
9W006 and 9W007 67