Cabletron Systems SmartSwitch 9W006 User Manual page 170

USER'S GUIDE
Alerting on - pattern <pattern number>
Informational call trace message. This indicates additional details on the <signal value> received in
the "call progress" information message.
Answer tone on
Informational call trace message. This message is used to indicate additional details on the <signal
value> received in the "call progress" information message.
Call has returned to the ISDN
Informational call trace message.
Call is not end-to-end ISDN
One or more of the WAN phone networks used to connect the call is not an ISDN network. The call
must be at 56 Kbps.
Call waiting tone on
Informational call trace message. It indicates additional details on the <signal value> received in
the "call progress" information message.
Custom tone on
Informational call trace message.
Delay in response at called interface
Informational call trace message.
Destination call address is non-ISDN
Informational call trace message.
Dial tone on
Informational call trace message.
Disconnect for <tone value> tone on
This message indicates that the system disconnected the outbound call. The <tone value> values
are: error tone, busy verify, confirm, busy, network congestion, or intercept. These tone values
indicate a temporary network failure. Check the outbound phone number and try again. If the
problem persists, contact your phone company.
Expensive routing tone on
Informational call trace message.
In - ABNORMAL RPT Call Id=<call Id> Slot=<slot # > Port=<port # > ConnId=<connect Id>
Ces=<communication endpoint suffix>
The system has detected an internal error condition. The <parameters> are included for your
Distributor or Cabletron Customer Support. An error message describing the problem should be
reported following this trace message.
In - ABNORMAL RSP Slot=<slot # > Port=<port # > Ces=<communication endpoint suffix> Err=<error>
Sev=<severity> State=<state>
The system has detected an invalid internal message type. Contact your Distributor or Cabletron
Customer Support. The <parameters> are included for your Distributor or Customer Support.
170 SmartSwitch Remote Access Module