Cabletron Systems SmartSwitch 9W006 User Manual page 120

USER'S GUIDE
Capability upgrade processing error - <caperror>.
Upgrade file was ignored.
A problem has occurred during system upgrade. The <caperror> will further identify the problem:
• File not found
• Could not open file
• File already exists
• Header corruption
• File write problem
• Hash key mismatch
• Invalid serial number
• Invalid capability type
• Invalid capability format
• Invalid capability value
The system will revert to its original level and the upgrade process will not be allowed. Contact
your Distributor or Customer Support.
Note: Duplicating serial numbers on all systems is a license violation.
Cause <cause code> received for DLCI <dlci index>
A CLLM message was received indicating that the PVC associated with the indicated DLCI is
subject to the event denoted by the indicated cause code. These events are listed below with their
corresponding cause code:
Cause Code
CB disconnect:(1) Password Incorrect
CB disconnect:(2) Call-back number not found
CB disconnect:(3) Ethernet address inconsistent
CB disconnect:(4) Disconnecting for Call-back
CB disconnect:(5) Invalid Packet Received
CB disconnect:(6) Unable to resolve protocols
CB disconnect:(7) Inband Timeout
CB disconnect:(8) Line Integrity Violation
CB disconnect:(?) Unspecified
For all of the above Combinet generated messages, the Combinet has disconnected for the indicated
reason. Check your Combinet configuration, and adjust if necessary. If problem persists, contact
your Combinet distributor.
[CCP] Internal Decompression Failure
The system was unable to decompress a packet though the frame was delivered properly from a
protocol perspective. This is an unexpected condition with a properly functioning device
implementation and is thus considered a unrecoverable error. The system will close the CCP
protocol, meaning that the connection continues to operate, but in an uncompressed mode.
120 SmartSwitch Remote Access Module
Event
2 Mild congestion
3 Severe congestion
7 Fixed fault notification: facility/equipment
failure
10 Discard all frames: maintenance action in
progress