Snmp Commands - Cabletron Systems SmartSwitch 9W006 User Manual

While the "pkt display" is displayed on your monitor, you can display the following help
screen by entering "?":
ESC - Exit Menu
'u' - Previous Menu
'd' - Next Menu
'h' - Top of Packet List
'e' - End of Packet List
Enter - Display Packet Details
't' - Time Menu
'm' - Marks Packet as Start Time
Cursor- to select an entry
The time menu that is displayed when "t" is entered will enable you to toggle the time
increment to be in either Sec (seconds), mSec (milliseconds), or tSec (deciseconds).
When the packet marking option is used, all packet times will be displayed relative to that
marked packet. To mark a packet, use the arrow keys to move the cursor to the selected packet
number, then press "m" The time for that packet will be set to 0. All packets received before that
packet will have negative time values. All packets received after that marked packet will have
progressively higher positive time values.
SNMP C
OMMANDS
When the SNMP Agent is enabled on the SmartSwitch Remote Access Module, the following
command is available:
snmp stats
Displays the current SNMP related statistics. Refer to
statistics and their definitions.
S T C
PANNING REE
Spanning Tree protocol is supported only on the two port Ethernet-2 adapter card. The Ethernet-1
adapter card does not support Spanning Tree protocol, but does have access to the "BRIDGE AGE
TIME" Spanning Tree Information.
When Spanning Tree protocol is enabled on the SmartSwitch Remote Access Module, the following
commands are available:
br stpport <port #>
Displays Spanning Tree port information for the specified port number (either "1" or "2").
br stpbrdg
Displays Spanning Tree bridge information.
Hit any key to exit Help
OMMANDS
S
YSTEM

SNMP Commands

SNMP Statistics, for a list of available
9W006 and 9W007
C
OMMANDS
225