Ipx Routing Over The Wan Connection; Triggered Rip/Sap Start Up; Triggered Rip/Sap Operation - Cabletron Systems SmartSwitch 9W006 User Manual

IPX R
OUTING OVER THE
Problem:
The remote NetWare server does not appear in the NetWare client's network neighborhood.
Action:
1. Verify that the SmartSwitch Remote Access Module has SAP process enabled. To do this:
a. If it is not already running, start up SFVRA-CFG.
b. From the toolbar, select Functions, then IPX Network, then Systems, or click on the
icon.
c. Select the system's site from displayed list (you should have already configured IPX
segment information for this site).
d. Click on the Network Interface tab.
e. Select the appropriate interface.
f. Click on the Expert Options tab.
g. Check to see that the SAP Configuration value is set to Send.
h. If you made any changes to the configuration, download the updated configuration files to
the effected site.
For more detailed instructions, refer to the following sections in the SFVRA Configuration
Manager User's Guide:
• For network interfaces: refer to Configuring IPX Network System Interfaces in the Configuring
IPX Network Information chapter.
• For downloading configuration files: refer to Downloading Configuration Updates in the
Exporting Configuration Files chapter.
T RIP/SAP S
RIGGERED
Problem:
The SmartSwitch Remote Access Module does not display a triggered RIP/SAP starting message
for a WAN peer.
Action:
Verify that the WAN peer is properly configured. Be sure that the device (WAN peer) has IPX
routing enabled and triggered RIP/SAP (active) selected as routing protocol.
T RIP/SAP O
RIGGERED
Problem:
Routes or Services are not propagated between peers.
Changes are not propagated between peers.
WAN C
ONNECTION
U
TART P
PERATION
P D
ROBLEM IAGNOSIS
IPX Routing
9W006 and 9W007 95