Verifying Ip Rip Input Processing On Alan Interface - Cabletron Systems SmartSwitch 9W006 User Manual

USER'S GUIDE
• For downloading configuration files: refer to Downloading Configuration Updates in the
Exporting Configuration Files chapter.
2. Determine if a local IP Host A has learned the route to 192.1.1.0 from System A. On IP Host A
type:
netstat -r <return>
If the route to 192.1.10 is displayed, the IP RIP output processing is operational.
If the route is NOT displayed, refer to
Diagnosis chapter.
V IP RIP I
ERIFYING NPUT
To verify that IP RIP Input Processing (routes learning) is properly operational on a LAN interface,
IP RIP processing must be successfully initialized. Also, a local IP router must be connected to the
local LAN port on the system and capable of propagating routes information via RIP.
Below is an example of a configuration used to verify IP RIP input processing on a LAN interface.
It uses IP addresses specified to the example. Substitute the IP addresses of your network when you
perform the verification steps. It also uses the netstat command. The netstat command
displays the IP routing table of the system. Substitute the equivalent command on your IP router.
64 SmartSwitch Remote Access Module
IP RIP Output Processing on a LAN Interface
P LAN I
ROCESSING ON A
128.1.1.1
MMAC PLUS
C a b l e t r o n
Systems
MMAC-Plus with
SmartSWITCH
Remote Access Module
NTERFACE
LAN 131.1.0.0
131.1.1.16
Router 1
128.1.1.16
in the Problem