Ip Routing Over Awan Interface Connection - Cabletron Systems SmartSwitch 9W006 User Manual

USER'S GUIDE
d. Click on the Network Interfaces tab.
e. Double click on the interface in question.
f. Click on the Expert Properties tab.
g. Check the value for the Packet Encapsulation type. Compare the value to the host's value.
If they are not the same, change the value to make them the same.
h. If you made any changes, download the new configuration files to the site.
For more detailed instructions, refer to the following sections in the SFVRA Configuration
Manager User's Guide:
• For static routes: refer to Configuring IP Network Subnet Interfaces in the Configuring IP
Network Information chapter.
• For downloading updated configuration files: refer to Downloading Configuration Updates in
the Exporting Configuration Files chapter.
5. Try to ping the Host from another device on the LAN. If this is also unsuccessful, this may
indicate a problem with the Host.
6. Verify that the hardware address (MAC address) for the IP Host in the system's ARP cache is
correct. If it is not correct, verify the configuration in the IP Host.
IP R O
OUTING VER A
Problem:
The remote IP Host connected to a WAN interface does not receive a ping response from the
SmartSwitch Remote Access Module WAN interface.
Action:
1. Verify that the WAN connection is up. Use the mc console command to display the Connection
Monitor display. Check for the connection. If the connection is up, continue with the next step.
If the connection is not up, refer to the section titled
2. Verify that the WAN interface is properly initialized. Use SFVRA-CFG to check for the proper
WAN interface (refer to
If the proper WAN interface does not exist, make corrections to the system configuration using
SFVRA-CFG.
3. Check that the IP address configured for the IP Host device matches the address configured on
the IP Host device. Make corrections to the SmartSwitch Remote Access Module's
configuration (using SFVRA-CFG), or to the IP Host's configuration, as required. To do this:
a. If it is not already running, start up SFVRA-CFG.
b. From the toolbar, select Functions, then IP Network, then Systems, or click on the
84 SmartSwitch Remote Access Module
WAN I C
NTERFACE ONNECTION
page 77 for instructions). If it exists, continue with the next step.
Remote Device Connectivity.
icon.