Cabletron Systems SmartSwitch 9W006 User Manual page 142

USER'S GUIDE
LAN Adapter FIFO Data Underrun
The system expected data from the adapter that it did not receive, and the system will continue to
operate. Check for proper LAN adapter configuration and hardware installation.
LAN Adapter FIFO not empty, status=<status value>
The LAN adapter did not enter the proper state after it was restarted. Check for proper LAN
adapter configuration and hardware installation.
LAN Adapter HW upgrade may be required
Older versions of the Ethernet adapter may need to be updated to run Release 2.3 or greater. If the
above message appears in your system log messages, you will need to remove your Ethernet
adapter to determine if it is a version that needs to be updated. Refer to the "Notes and Warnings"
section of the Release Notes for further instructions.
LAN Adapter HW upgrade required
Older versions of the Ethernet adapter may need to be updated to run Release 2.3 or greater. If the
above message appears in your system log messages, you will need to upgrade your Ethernet
adapter.
LAN Adapter LAN Controller error
The system detected an error with the LAN controller. The LAN adapter card may be faulty.
Contact your Distributor or Customer Support.
LAN Adapter not configured
The system tried to access the bridging function when it was not configured. Most likely, the
Ethernet resource was accidentally deleted. Correct the system configuration to reflect the proper
Ethernet resource.
LAN Adapter out of receive buffers for LAN port <port # >
The LAN adapter is temporarily out of receive buffers for the indicated port. This condition should
clear itself. If the condition persists, contact your Distributor or Customer Support.
LAN Adapter out of receive buffers for the WAN port
The LAN adapter is temporarily out of the buffers it uses to receive packets from the WAN port.
This condition should clear itself. If the condition persists, contact your Distributor or Customer
Support.
LAN Adapter port <port # > transmit error <error code>, check connection
The LAN adapter detected an error transmitting a frame on the indicated port. Check that the LAN
is properly connected to the adapter and that the LAN is properly terminated.
LAN Adapter Reset
This is an initialization message. The Ethernet adapter has been reset as part of the adapter
initialization sequence.
LAN Adapter Response Timeout
The system expected a command response from the adapter that it did not receive. Check for
proper hardware installation.
LAN Adapter ROM version # # # # # # # # .# # # # # # # # .# # # # # # # #
The ROM version in the Ethernet adapter is indicated.
142 SmartSwitch Remote Access Module