Cabletron Systems SmartSwitch 9W006 User Manual page 190

USER'S GUIDE
Modem Type
You must change the modem type from the default of "Direct Connect" to your modem's brand
name. To make this change, enter a menu selection of "C" (for Modem Type). A list of modem types
will be displayed. Arrow down to the type of modem you have installed. If the type of modem you
have installed is not included on the list, select Hayes Smartmodem.
You will then be asked if you want to use the Modem's default baud rate. Answer either yes or no
by entering Y or N.
Baud Rate
If you wish to enter a new baud rate, enter a menu selection of "B "(for Baud Rate). Continue to
press B until the baud rate you desire is displayed.
When you have finished making Carbon Copy configuration parameter changes, enter a menu
selection of "X" to save your changes and exit the CCINSTAL program. You will be asked if you
wish to update the presently running Carbon Copy. Enter "Y" for yes. Carbon Copy will then be
reinitialized and you will be returned to the MSDOS prompt.
U I
SAGE NSTRUCTIONS
E R
STABLISHING A EMOTE
When using the remote administration console option, Carbon Copy establishes an administration
session with the SmartSwitch Remote Access Module. This section contains a brief description of
establishing an administration session using Carbon Copy.
1. If you did not install the Manager software onto the administration console PC (see
System Software) then insert the Manager software diskette into the diskette drive on the
administration console PC.
2. Set the administration console PC to the disk drive containing the Manager software (replace
"drive letter" with the appropriate administration console PC drive, for example, "A" or "C").
Type:
<drive letter>:<return>
3. Set the administration console PC to the directory containing the Manager software. Type:
cd \admin<return>
4. Load the Carbon Copy CCHELP program on the administration console PC. Type:
cchelp<return>
Within 3 to 10 seconds, Carbon Copy will be displayed on the screen. The screen is divided into
three sections. In the lower right hand corner is the Carbon Copy command screen. It is
function-key driven and provides the following commands:
[F1]
[F3]
[F4]
[F6]
[F7]
[F8]
[F10]
190 SmartSwitch Remote Access Module
A S
DMINISTRATION ESSION
Call CC Device
Capture Screen/Session
Review/Replay Captured Image
Printer/LOG/DOS Control
Terminal Emulation
Data Link Maintenance
Return to Application
Upgrading