Cabletron Systems SmartSwitch 9W006 User Manual page 235

wan l1p rem_loop [disable or enable] <slot #>
Disables or enables a remote loopback. When enabled, this loopback feeds the network's
transmit back to the network's receive. This is useful for allowing switch personnel to test the
entire connection from the switch to the PRI adapter and back.
wan l1p stats [display or clear] <slot #>
When display is used, this command displays the PRI layer 1 statistics. Two sets of statistics
are provided: the specific PRI interface statistics, and layer 1 general statistics. Refer to
L1P Statistics for a list of available statistics and their definitions.
When clear is used, these statistics are cleared.
wan stats
Displays the current WAN statistics. Refer to
their definitions.
WAN Statistics for a list of available statistics and
9W006 and 9W007
S C
YSTEM OMMANDS
WAN Commands
WAN
235