Cabletron Systems CyberSWITCH CSX5500 Release Note
Csx central site cyberswitch software version uaa 7.4
Hide thumbs
Also See for CyberSWITCH CSX5500:
- User manual (729 pages) ,
- User manual (178 pages) ,
- Quick start manual (42 pages)
Advertisement
Quick Links
Download this manual
See also:
User Manual
INTRODUCTION:
This software provides the CyberSWITCH modular remote access platforms with maximum flexibility in central
site environments. It supports a wide variety of communication technologies – including ISDN (primary and
basic rate interfaces), Frame Relay, X.25 and Dedicated Services (PPP, ML-PPP). The software supports
bridging as well as IP, IPX, and AppleTalk routing standards. Security features include Device Authentication
(PAP, CHAP, Calling Line ID), User Authentication, and off-node Authentication via Radius, TACACS, ACE, or
Cabletron's Connection Services Manager (CSM) . (CSM replaces the former SecureFast
Access Manager - or SFVRA - available with previous releases).
It is recommended that one thoroughly review this release note prior to the installation or upgrade
of this product.
SOFTWARE SPECIFICATION:
Status
Current Version
Previous Version
HARDWARE COMPATIBILITY:
Platforms supported for UAA Release 7.4 are:
* 9W006
* 9W007
* CSX7000
* CSX6000
* CSX5500
* NE7000
* NE5000
* NE4000
* NE2000-II
Note that there is a four WAN card limitation for the CSX6000 and CSX5500 platforms.
BOOTPROM COMPATIBILITY:
N/A
06/99 P/N: 9032577-02
F0615-C
Central Site CUSTOMER RELEASE NOTES
CSX Central Site CyberSwitch
Software Version UAA 7.4
June, 1999
Version No.
UAA 7.4
UAA 7.3
Subject to Change Without Notice
Type
Release Date
Customer
Customer
35 Industrial Way
PO Box 5005
Rochester, NH 03867-5005
(603) 332-9400
TM
Virtual Remote
6-99
6-98
1
Page:
Advertisement
Related Manuals for Cabletron Systems CyberSWITCH CSX5500
Summary of Contents for Cabletron Systems CyberSWITCH CSX5500
- Page 1 INTRODUCTION: This software provides the CyberSWITCH modular remote access platforms with maximum flexibility in central site environments. It supports a wide variety of communication technologies – including ISDN (primary and basic rate interfaces), Frame Relay, X.25 and Dedicated Services (PPP, ML-PPP). The software supports bridging as well as IP, IPX, and AppleTalk routing standards.
-
Page 2: Supported Functionality
CSXBRI-4 Support (Four Port BRI Interface); North America only CSXV35 Support (V.35 Interface) CSX232 Support (RS-232 Interface) Single Port Ethernet Interface (10Mbit) Support Dual Port Ethernet Interface (10Mbit) Support DMS500 Switch Type Support Accesses ISDN Primary Rate ISDN Basic Rate H0 Call Support RFC 1490 Compliance Frame Relay Connections (using PPP) X.25 Connections (RFC 877) - Page 3 Bridging Full Bridge Dial-Out Proxy ARP Combinet Support for Ordered and Compression Protocol Spanning Tree Protocol AppleTalk Routing AppleTalk Routing AppleTalk RLAN IP Routing IP Host Mode UnNumbered IP Network Interface 255 Static IP Routes Definable IP RIP IP RLAN Static ARP Entries for IP Routing 25-bit Subnet Masks IP Address Pool...
- Page 4 Connection Management Global Call Control Settings Connection Throughput Monitor Configurable Call Interval Bandwidth Reservation Bandwidth Agility Digital Modem Inactivity Timer Call Detail Recording for both ISDN and Terminal devices RADIUS Accounting Support NET5 D-Channel Callback Modem Callback V.90 Modem Support Security Features PPP PAP Support PPP CHAP Support...
- Page 5 4. Telnet to the CyberSWITCH and issue the restart command. SOFTWARE CHANGES AND ENHANCEMENTS: NET5 D-Channel Callback Modem Callback V.90 Firmware Modem Firmware revision reported on VER command DMS500 phone switch support CSX-Y2K-SW-UGK support 06/99 P/N: 9032577-02 F0615-C Central Site CUSTOMER RELEASE NOTES Subject to Change Without Notice...
- Page 6 KNOWN RESTRICTIONS AND LIMITATIONS: Bridging Software: Bridge Dial-Out is not provided for IP Host (RFC 1294) devices . IP Routing Software: Under very special circumstances, an IP address from the IP address pool could be assigned to two different devices. If a device calls in with a static address that is within the WAN interface’s subnet, and then the DHCP proxy client is enabled in manage mode and receives addresses in the same range as the one in use by the currently connected device, another device could connect and request an address from the IP address pool and receive the one which is in use by...
-
Page 7: Memory Usage
H0 Calls: H0 Calls are not supported on NET5 switches. Solution: The initial configuration to enable H0 calls for users must be done in CFGEDIT. Subsequent changes may be made in either Manage Mode or CFGEDIT. Any other problems than those listed above should be reported to our Technical Support Staff. See section titled Global Call Support for contact information. - Page 8 1378 AppleTalk Control Protocol (ACP) 1490 Multiprotocol Interconnect over Frame Relay 1492 TACACS 1570 PPP LCP Extensions 1573 MIB-II (evolution of the Interfaces Group) 1634 IPXWAN 1638 Bridge Control Protocol (BCP) 1661 Point-to-Point Protocol (PPP) 1717 Multi-link Point-to-Point Protocol (MLPPP) 1812 Requirements for IP Version 4 Router 1825...
- Page 9 STANDARD IETF TRAP SUPPORT: Title coldStart Trap warmStart Trap linkDown Trap linkUp Trap authenticationFailure Trap CABLETRON PRIVATE ENTERPRISE TRAP SUPPORT: Title authenticationServerTimeoutTrap callingLineIdDisconnectTrap isdnUsageHighTrap isdnUsageNormalTrap cdrOutOfBufferTrap GLOBAL CALL SUPPORT: If you have any questions or require any assistance contact Cabletron Systems Global Call Center : By phone: (603) 332-9400 By CompuServe®: GO CTRON from any ! prompt By Internet mail: support@ctron.com...