Cabletron Systems SmartSwitch 9W006 User Manual page 144

USER'S GUIDE
[LCP] Option Negotiation Failure, Non-Convergence detected
Link Control Protocol is terminated because the SmartSwitch Remote Access Module and the
device cannot agree on a common way of communicating. The device may not be configured
properly. Refer to the specific documentation for device set up. Then, contact your Distributor or
Customer Support.
Line <slot # , port # > Down
ISDN line failure. The data link for the line connected to slot <slot # > port <port # > is down.
LMI alarm on Access <access index>
Indicates that either no STATUS messages have been received from the network or that N393 errors
have occurred in the last N391 events thus exceeding the device configured alarm threshold for the
LMI link. Any associated PVCs are disabled. (The variable N393 is the configured Monitored
Events Count, and the variable N391 is the configured Full Status Enquiry Polling Count.)
LMI alarm reset Access <access index>
Indicates that N392 events have occurred which allows the LMI alarm condition to be cleared and
any associated PVCs to be re-enabled. (The variable N392 is the configured Error Threshold Count.)
Loop detected on Local Area Network
The LAN adapter has detected a loop condition on the local area network. The system will discard
these frames until the loop condition is removed.
MAC Layer Bridge did not Initialize
A system problem prevented the MAC layer bridge from properly initializing, and the bridge will
not forward data over the WAN. Restart the system. If the error continues, contact your Distributor
or Customer Support.
Manual intervention required: please replace LAN card
Older versions of the Ethernet adapter may need to be updated or replaced to run Release 2.3 or
greater. If the above message appears in your system log messages, you will need to replace your
Ethernet adapter.
Manual restart initiated on DM board in slot <slot # >
There was an attempt to restart the specified Digital Modem with the modem restart command.
Check subsequent log messages to verify the command was successful.
Maximum call charges exceeded for month
The configured maximum for monthly call charges has been exceeded.
Maximum call minutes per day limit (x) has been reached
The described limit has been exceeded. The next log message will indicate whether calls will still
be allowed or not.
Maximum call minutes per month limit (x) has been reached
The described limit has been exceeded. The next log message will indicate whether calls will still
be allowed or not.
Maximum calls per day limit (x) has been reached
The described limit has been exceeded. The next log message will indicate whether calls will still
be allowed or not.
144 SmartSwitch Remote Access Module