Removing The Steering Arm; Installing The Steering Arm - SELVA MARINE Pike 9,9 Service Manual

BRKT
4. Install the baffle plate A and rubber seal
B to the oil pan C, and then tighten the
oil pan bolts D to the specified torque.
LT LT
572
C
B
Oil pan bolt D:
21 N·m (2.1 kgf·m, 15.5 ft·lb)
5. Install the dowels E and oil pan assem-
bly F, and then tighten the upper case
bolts G to the specified torque.
6. Install the upper mount H, and then
tighten the upper mount bolts I to the
specified torque.
LT LT
572
H
1104J
E
NOTE:
Apply sealant (1104J) to the mating surface.
7-23
Bracket unit
D
LT LT
572
A A
A
S6AU7027
I
E
J
LT LT
572
G
S6AU7031
Upper case bolt G:
Upper mount bolt I:
7. Install the grommet and engine oil drain
bolt J, and then tighten the drain bolt to
the specified torque.
Engine oil drain bolt J:

Removing the steering arm

1. Remove the steering arm 1 from the
swivel bracket 2 by pulling the arm off
the bracket.
1
F
NOTE:
To disassemble the clamp brackets, see
"Removing the clamp bracket" (7-28) or
"Removing the clamp bracket" (7-33).

Installing the steering arm

1. Install the washer 1 and bushing 1 2
onto the steering arm.
2. Place the swivel bracket 3 in an upright
position, and then install the steering arm
onto the swivel bracket.
3. Install bushing 2 4, a new O-ring 5, and
the plate 6 onto the swivel bracket.
18 N·m (1.8 kgf·m, 13.3 ft·lb)
11 N·m (1.1 kgf·m, 8.1 ft·lb)
24 N·m (2.4 kgf·m, 17.7 ft·lb)
7
2
S6AU7032
7
6AU3K11