Removing The Steering Arm; Installing The Steering Arm - SELVA MARINE Wahoo 15 Service Manual

4. Install the upper mount 9, and then
tighten the upper mount bolts 0 to the
specified torque.
5. Install the water pipe A.
5
A A
6
6
LT LT
572
8
8
5
A
NOTE:
Be sure to pass the water pipe A through the
water pipe guide 5.
Oil pan assembly bolt 8:
18 N·m (1.8 kgf·m, 13.3 ft·lb)
Upper mount bolt 0:
30 N·m (3.0 kgf·m, 22.1 ft·lb)
6. Install the damper and engine oil drain
bolt, and then tighten the drain bolt to the
specified torque.
Engine oil drain bolt:
27 N·m (2.7 kgf·m, 19.9 ft·lb)

Removing the steering arm

1. Remove the steering arm 1 from the
swivel bracket 2 by pulling the arm off
the bracket.
6AG3J11
A
0
LT LT
572
9
LT LT
572
7
S6AG7660
7
Upper case and steering arm
1
NOTE:
To disassemble the clamp brackets, see
"Removing the clamp bracket" (7-22) or
"Removing the clamp bracket" (7-27).

Installing the steering arm

1. Install the washer 1 and bushing 1 2
onto the steering arm.
2. Place the swivel bracket 3 in an upright
position, and then install the steering arm
onto the swivel bracket.
3. Install bushing 2 4, a new O-ring 5, and
the plate 6 onto the swivel bracket.
A A
1
2
A A
2
S6AG7711
7
3
4
5
6
A A
S6AG7710
7-18
1
2
3
4
5
6
7
8
9