Copy Function Related Displays - YASKAWA iQpump Micro CIMR-PW Series User Manual

6.6

Copy Function Related Displays

Tasks, Errors, and Troubleshooting
u
The table below lists the messages and errors that may appear when using the Copy function.
When executing the tasks offered by the Copy function, the keypad will indicate the task being performed. When an error
occurs, a code appears on the keypad to indicate the error. Note that errors related to the Copy function do not trigger a multi-
function output terminal that has been set up to close when a fault or alarm occurs. To clear an error, simply press any key on
the keypad and the error display will disappear.
Table 6.5 lists the corrective action that can be taken when an error occurs.
Note: 1. The drive should be fully stopped when using the copy function.
2. The drive will not accept a Run command while the Copy function is being executed.
3. Parameters can only be saved to a drive when the voltage class, capacity, control mode, and software version match.
LED Display LCD Display
copy
Cause
Parameters are being written to the drive.
LED Display LCD Display
cpye
CoPyE
Cause
Failed writing parameters
LED Display LCD Display
c5er
Cause
Hardware fault
LED Display LCD Display
dfp5
Cause
The drives used in the copy and write process
are not the same model.
• The drive from which the parameters were
copied is a different model.
• The drive to be written to is a different
model.
LED Display LCD Display
end
Cause
Finished reading, writing, or verifying
parameters.
LED Display LCD Display
ifer
Cause
A communication error occurred between
the drive and the HOA keypad or the USB
copy unit.
A non-compatible cable is being used to
connect the USB Copy Unit and the drive.
YASKAWA TOEP YAIQPM 03B YASKAWA AC Drive - iQpump Micro User Manual
Table 6.5 Copy Function Task and Error Displays
Writing Parameter Settings (flashing)
CoPy
This is not an error.
Error Writing Data
Attempt to write parameters again.
Copy Unit Error
CSEr
Replace the HOA keypad or the USB Copy Unit.
Drive Model Mismatch
dFPS
• Verify the model number of the drive from which the parameters were copied and the model of the drive
to which those parameters will be written.
• Make sure the two drives are the same model and have the same software version.
Task Complete
End
This is not an error.
Communication Error
iFEr
Check the cable connection.
Use the cable originally packaged with the USB Copy Unit.
6.6 Copy Function Related Displays
Task
Possible Solutions
Task
Possible Solutions
Task
Possible Solutions
Task
Possible Solutions
Task
Possible Solutions
Task
Possible Solutions
6
283