Copy Function Related Displays; Copy Function Related Displays; Tasks, Errors, And Troubleshooting - YASKAWA FSDrive-MV1000 Instructions Manual

5.9 Copy Function Related Displays

5.9

Copy Function Related Displays

◆ Tasks, Errors, and Troubleshooting

The table below lists the messages and errors that may appear when using the Copy function.
When executing the tasks offered by the Copy function, the digital operator indicates the task being performed. When an
error occurs, a code appears on the digital operator to indicate the error. Note that errors related to the Copy function do
not trigger a sequence terminal set for fault or alarm output. To clear an error, simply press any key on the LCD operator.
Refer to Table 5.18 to take proper measures and remove the cause.
Note: 1. Whenever using the copy function, the drive should be fully stopped.
2. The drive will not accept a Run command while the Copy function is being executed.
3. Parameters can only be saved to an drive when the voltage class, capacity, control mode, and software version match.
Digital Operator Display
CoPy
Cause
Parameters are being written to the drive.
Digital Operator Display
CPEr
Cause
Control mode of the parameters to be loaded
onto the drive and the control mode already
set to the drive don't match.
Digital Operator Display
CPyE
Cause
Failed writing parameters.
Digital Operator Display
CSEr
Cause
Hardware fault
Digital Operator Display
dFPS
Cause
The drive from which the parameter were
copied and the drive you are attempting to
write to are not the same model.
• The drive the parameters were copied from
is a different model drive.
• The drive you are attempting to write to is a
different model.
Digital Operator Display
End
Cause
Finished reading, writing, or verifying
parameters.
Digital Operator Display
iFEr
Cause
A communication error occurred between the
drive and the digital operator or the USB
Copy Unit.
A non-compatible cable is being used to
connect the USB Copy Unit and the drive.
148
Table 5.18 Copy Function Task and Error Displays
Writing Parameter Settings (flashing)
Not an error.
Control Mode Mismatch
Check the control mode for the parameters that are to be loaded onto the drive and the
control mode set to the drive those parameters will be written to.
⇒Set the same control mode using parameter A1-02 and try again.
Error Writing Data
⇒Try writing parameters again.
Copy Unit Error
⇒Replace the digital operator or the USB Copy Unit.
Drive Model Mismatch
Check the model number of the drive that the parameters were copied from and the model
of the drive you are attempting to write those parameters to.
⇒Make sure the drive from which the parameter are copied and the drive to be written to
have the same model numbers and software versions.
Task Complete
Not an error.
Communication Error
⇒Check the cable connection.
⇒Use the cable originally packaged with the USB Copy Unit.
Error Name
Possible Solution
Error Name
Possible Solution
Error Name
Possible Solution
Error Name
Possible Solution
Error Name
Possible Solution
Error Name
Possible Solution
Error Name
Possible Solution
YASKAWA ELECTRIC EZZ010928 FSDrive-MV1000 Instructions