YASKAWA iQpump Micro CIMR-PW Series User Manual page 113

1.
Press to display A1-01.
2.
Press to display the value set to A1-01.
3.
Press and , making sure that the setting values cannot be changed.
4.
Press to return to the first display.
Table 5.4 Enter the Password to Unlock Parameters (continuing from step 4 above)
1.
Press to enter the parameter setup display.
2.
Press to select the flashing digits as shown.
3.
Press to scroll to A1-04.
4. Enter the password "1234".
5.
Press to save the new password.
6.
Drive returns to the parameter display.
7.
Press and scroll to A1-01.
Press to display the value set to A1-01. If the first "0" blinks, parameter settings
8.
are unlocked.
9.
Use and to change the value if desired. This is not typical.
10. Press to save the setting, or
changes.
11. The display automatically returns to the parameter display.
Note: Parameter settings can be edited after entering the correct password. Performing a 2-Wire or 3-Wire initialization resets the password to
"0000". Reenter the password to parameter A1-05 after drive initialization.
A2: User Parameters
u
A2-01 to A2-32: User Parameters
n
The user can select 32 parameters and assign them to A2-01 through A2-32. This saves time later scrolling through the
parameter menu. The list of User Parameters can also track the most recently edited settings and save those parameters to this
list.
No.
A2-01 to A2-32
Saving User Parameters
To save specific parameters to A2-01 to A2-32, first set the access level to allow access to all parameters (A1-01 = 2). Next
assign the parameter number to the User Parameters list by entering it into one of the A2-oo parameters. By then setting
A1-01 to "1", the access level can be restricted so that users can only set and reference the specific parameters saved as User
Parameters.
A2-33: User Parameter Automatic Selection
n
A2-33 determines whether or not parameters that have been edited are saved to the User Parameters (A2-17 to A2-32) for
quick, easy access.
YASKAWA TOEP YAIQPM 03B YASKAWA AC Drive - iQpump Micro User Manual
Table 5.3 Check to see if A1-01 is locked (continuing from step 10 above)
Step
Step
to return to the previous display without saving
Parameter Name
User Parameters 1 to 32
5.1 A: Initialization
Display/Result
"01" flashes
Display/Result
"01" flashes
Setting Range
Depending on
b1-01 to S6-02
5
Default
A1-03
113