Copy Function Related Displays; Copy Function Related Displays; Tasks, Errors, And Troubleshooting - YASKAWA AC Drive-A1000 Technical Manual

6.8 Copy Function Related Displays

6.8

Copy Function Related Displays

u

Tasks, Errors, and Troubleshooting

The table below lists the messages and errors that may appear when using the Copy function.
When executing the tasks offered by the Copy function, the operator will indicate the task being performed. When an error
occurs, a code appears on the operator to indicate the error. Note that errors related to the Copy function do not trigger a multi-
function output terminal that has been set up to close when a fault or alarm occurs. To clear an error, simply press any key on
the operator and the error display will disappear.
Table 6.18 lists the corrective action that can be taken when an error occurs.
Note: 1. Whenever using the copy function, the drive should be fully stopped.
2. The drive will not accept a Run command while the Copy function is being executed.
3. Parameters can only be saved to a drive when the voltage class, capacity, control mode, and software version match.
Digital Operator Display
Cause
Parameters are being written to the drive.
Digital Operator Display
Cause
Control mode of the parameters to be loaded onto
the drive and the control mode already set to the
drive don't match.
Digital Operator Display
Cause
Failed writing parameters.
Digital Operator Display
Cause
Hardware fault
Digital Operator Display
Cause
The drive from which the parameter were copied
and the drive you are attempting to write to are not
the same model.
• The drive the parameters were copied from is a
different model drive.
• The drive you attempting to write to is a different
model.
Digital Operator Display
Cause
Finished reading, writing, or verifying parameters. Not an error.
Digital Operator Display
Cause
A communication error occurred between the drive
and the operator or the USB copy unit.
A non-compatible cable is being used to connect
the USB Copy Unit and the drive.
332
Table 6.18 Copy Function Task and Error Displays
CoPy Writing Parameter Settings (flashing)
Not an error.
CPEr Control Mode Mismatch
Check the control mode for the parameters that are to be loaded onto the drive and the control mode
set to the drive those parameters will be written to. Set the same control mode using parameter A1-02
and try again.
CPyE Error Writing Data
Try writing parameters again.
CSEr Copy Unit Error
Replace the operator or the USB Copy Unit.
dFPS Drive Model Mismatch
Check the model number of the drive that the parameters were copied from and the model of the
drive you are attempting to write those parameters to.
Make sure the drive from which the parameter are copied and the drive to be written to have the same
model numbers and software versions.
End Task Complete
iFEr Communication Error
Check the cable connection.
Use the cable originally packaged with the USB Copy Unit.
Possible Solutions
Possible Solutions
Possible Solutions
Possible Solutions
Possible Solutions
Possible Solutions
Possible Solutions
YASKAWA ELECTRIC SIEP C710616 31B YASKAWA AC Drive – A1000 Technical Manual
Task
Task
Task
Task
Task
Task
Task