Table of Contents
Advertisement
A.
If 12 volts is not present, there is an open circuit in the front frame (FF) harness between connector
X023 and connector X020 J3-3 wire 762 white. Locate the open and repair.
B.
If 12 volts is found, there is an open circuit in the lower frame (LF) harness between connector X023
and connector X293 wire 762 white. Locate the open and repair.
7.
Disconnect connector X293. Use the multimeter to check for continuity between connector X293 pin A and
chassis ground.
A.
If continuity is found, continue with step 8.
B.
If no continuity is found, the short to ground is in the 2 speed PRA jumper harness between connector
X293, connector X454 and connector X455 wire 762 white. Locate the short and repair.
8.
Disconnect connector X023. Use the multimeter to check for continuity between connector X023 pin 21 and
chassis ground.
A.
If continuity is found the short to ground is in the front frame (FF) harness between connector X023 and
connector X020 J3-3 wire 762 white. Locate the short and repair.
B.
If no continuity is found the short to ground is in the lower frame (LF) harness between connector X023
and connector X293 wire 762 white. Locate the short and repair.
9.
Visually inspect the harness and connectors for damage, bent or dislocated pins, corroded terminals or
broken wires.
A.
If no damage is found, erase the fault code and continue operation.
TRAVELLING - 2WD-4WD SYSTEM Hydraulic
9688 1 27/05/2004
D.14.C / 30
Advertisement
Chapters
Table of Contents
Troubleshooting
