Case IH AFX8010 Repair Manual page 1584

Control valve Two speed valve - Replace (D.14.C.14.11 - F.10.A.30)
AFX8010
•
NOTE: The two speed spool can be replaced without removing the motor from the C-frame
1. Turn the wheel to the steering stop to gain access
to the spool.
2. Release the pressure in the supply circuit.
3. Disconnect the drain line at the tank level to avoid
siphoning.
4. Remove the plug (1).
5. Extract the spool (3) with snap ring (2), washer (4)
and spring (5).
6. Remove the spring (5), washer (4), and snap ring
(2) from spool (3).
7. Install the snap ring (2), washer (4), and spring
(5)onto the new spool (3).
8. Oil, then install new spool assembly.
9. Re-install plug (1). Torque to 285 - 380 Nm (210 -
280 lb ft).
10. Reconnect the drain line and pressurize the supply
system.
11.
Bleed air from system by loosening bleed screw
(6) approximately one turn. Re-tighten after all air
is bled from the system.
TRAVELLING - 2WD-4WD SYSTEM Hydraulic
20042890
9688 1 27/05/2004
D.14.C / 24
1