Case IH AFX8010 Repair Manual page 2076

The rotor de-slug is used by the operator to rotate the rotor in forward and reverse to free a stalled rotor. All
•
driving force is provided by the rotor drive motor. Rotor De-Slug mode is activated by the separator engage
switch S-30 (momentary then maintained). The operator would:
1. Open the threshing modules completely.
2. Move the separator switch into the reverse position, (rearward momentary position).
3. Move the separator switch into the forward detented position.
4. Press the rotor speed increase switch to operate the rotor in forward mode and speed decrease switch
to operate the rotor in reverse mode.
5.
Return the separator engagement switch to the OFF position, (center-detented position) to exit the
de-slug state.
IMPORTANT: When activating the rotor "De-slug" mode the operator should also activate the feeder reverser.
IMPORTANT: When using the rotor "De-Slug" mode, the rotor drive gear box must be shifted into 1st or 2nd range
only, do not use "De-Slug" while operating in 3rd range.
The system will remain in the de-slug state until the separator switch S-30 is placed into the OFF position.
ROTOR DRIVE POWER FLOW - Power flow to the rotor may take one of two paths, or a combination of both.
Hydro, Mechanical, or a combination of both.
CROP PROCESSING - THRESHING Axial flow threshing
9714 1 27/05/2004
K.40.C / 6