Case IH AFX8010 Repair Manual page 1180

13. The dowel pin height should be 7 mm (0.28 in).
14. Sub-assemble the clutch piston (1) by inserting the
smaller O-ring and small seal (2) into groove in the
ID of the piston. Install the larger o-ring and larger
seal (3) into the groove on the piston OD.
15. Size the inner seal and outer seal on the clutch
piston (2). Lube both seals with petroleum jelly and
then press the piston onto the clutch shaft (1). Place
piston return spring (3) over shaft and into piston,
drop spring retainer (4) (lips toward spring) and
retain on shaft with external snap ring (5) (narrow
side up). This will require pressure to be applied to
spring with tool (long snap ring driver).
16. Assemble the clutch pack using 4 each of the
following: separator plate (3), friction plate (2),
separator plate, in this order until they are all used.
Use an aligning tool to align the friction plates.
After all separator plates and friction plates are in
place, seated, and aligned place the clutch backing
plate (4) on the stack and retain with backing plate
retaining ring (5) (narrow side up). Be sure retaining
ring (5) is fully seated into groove. Carefully insert 4
wedge pins, equally spaced, into assembly through
holes in sides to retain alignment.
POWER TRAIN - POWER COUPLING Fixed coupling
9679 1 27/05/2004
C.10.B / 14
13
50040358
14
10035840A5
15
10035841A5
16
10035842A5