Case IH AFX8010 Repair Manual page 1658

Front wheel - Install (D.50.C.60 - F.10.A.15)
AFX8010 Dual Wheel
1. Empty the grain tank and remove the header. Park
the combine on a hard, level surface. Engage
the parking brake and remove the key. Raise the
combine until the tire clears the ground and block
up the combine as required.
NOTE: When wheels are removed or repositioned,
mounting surfaces, washers and all threads must be
clean.
2.
Install two starter studs 144 ° opposite each other
on the final drive flange. Align the wheel so that
center small holes (1) align with the starter studs.
3. Install the inner wheel (1) (dish in) onto the final
drive, with small holes over the studs. Secure the
inner wheel to the studs using five M22 nuts (2).
NOTE: Do not use standard wheel nuts. Use only nuts
supplied in dual wheel mounting hardware kit.
TRAVELLING - WHEELS AND TRACKS Wheels
9693 1 27/05/2004
D.50.C / 4
1
50041653A5
2
20030328A5