Table of Contents
Advertisement
7.
Disconnect connector X072. Use a multimeter to check for continuity between connector X072 pin A and
chassis ground.
A.
If continuity is found, continue with Step 8.
B.
If no continuity is found, the short to ground is in the lower frame rear (LR) harness between connector
X072 and connector X233 wire 569 white. Locate the short and repair.
8.
Disconnect connector X024. Use a multimeter to check for continuity between connector X024 pin 15 and
chassis ground.
A.
If continuity is found, the short to ground is in the main frame (MF) harness between connector X024 and
connector X019 J2-16 wire 569 white. Locate the short and repair.
B.
If no continuity is found, the short to ground is in the straw walker (SW) harness between connector
X024 and connector X072 wire 569 white. Locate the short and repair.
9.
Disconnect connector X233. Use a multimeter to check for continuity between connector X233 pin B and
chassis ground.
A.
If there is continuity to ground, the circuit is functioning properly. Continue with Step 11.
B.
If there is no continuity to ground, continue with Step 10.
10.
Disconnect connector X072. Use a multimeter to check for continuity between the straw hood front (SW)
harness end of connector X072 pin B and chassis ground.
A.
If there is continuity to ground, there is an open circuit in the lower frame rear (LR) harness between
connector X233 and connector X072 wire 602 black. Locate the open and repair.
B.
If there is no continuity to ground, there is an open circuit in the straw hood front (SW) harness between
connector X072 and rear frame ground #1 wire 602 black or 479 black. Locate the open and repair.
11.
Visually inspect the harness and connectors for damage, bent or dislocated pins, corroded terminals or
broken wires.
A.
If no damage is found, erase the fault code and continue operation.
TRAVELLING - 2WD-4WD SYSTEM Hydraulic
9688 1 27/05/2004
D.14.C / 26
Advertisement
Chapters
Table of Contents
Troubleshooting
