Case IH AFX8010 Repair Manual page 2095

Threshing rotor AFX (auger front) rotor - Remove (K.40.C.52.52 -
F.10.A.10)
AFX8010
Prior operation: FEEDING Feeder housing - Remove (K.25.E - F.10.A.10)
1. Remove the separator grate covers from each side
of the combine.
2. Install the tool (1) used to secure the rotor
(#380000973) by threading the bolt through the
separator grate into a hole where a rasp bar bolt has
been removed. Be sure the bolt has been threaded
into the rotor securely, and the tool is resting against
the separator grate.
3. For added security lower the concaves all the way
down, and wedge a small block of wood between
the rotor and the concaves. With the block of wood
in place, raise the concaves until the block is tight
between the two.
4. Remove the five mounting bolts (1) and remove the
front cover.
5. Mark each auger plate and rotor to insure that they
are installed at the same locations.
CROP PROCESSING - THRESHING Axial flow threshing
9714 1 27/05/2004
K.40.C / 25
1
10030043A4
2
10030047B4