Shaft - Assemble (C.20.B.43 - F.10.A.20)
AFX8010
1.
To assemble the drive shaft, heat bearing (1) to 80
°C (176 °F ) and install it on the counter shaft.
CAUTION
47-41B - Use insulated gloves or mittens when
working with hot parts.
2.
Install needle bearings (1). Install gear (2). Install
selector housing (3). Install washer (4).
3.
Install retaining ring (3). Install two springs and two
balls (2) and at the same time install selector ring
(1).
NOTE: Be careful not to lose the balls.
POWER TRAIN - TRANSMISSION Mechanical
9680 1 27/05/2004
C.20.B / 53
1
3402a
2
3403a
3
3399a