Case IH AFX8010 Repair Manual page 1238

16. Install the cover with shims, seals and bearing cup,
and tighten nuts (1). Install two bolts (2). Torque the
M12 nuts to 80 - 90 Nm (59 - 66 lb ft ) .
17.
Install a dial gauge (1) on the gearbox housing and
locate the probe perpendicular against the side
of the gear (1). Apply a load in one direction and
oscillate the shaft several times while the load is
applied. Set the dial gauge to zero. Apply the load
in the opposite direction, oscillate and read the axial
movement of the shaft. Make three measurements
at 120 degrees of the intermediate shaft. The
average of the three readings, should be 0 - 0.03
mm (0 - .001 in). If required, adjust the shims. To
decrease the axial movement, decrease the number
of shims.
NOTE: Be sure to measure on gear (1) as the other gears
are mounted on needle bearings.
Next operation: Fork and shift rail - Install (C.20.B.56 - F.10.A.15)
POWER TRAIN - TRANSMISSION Mechanical
9680 1 27/05/2004
C.20.B / 48
16
3332a
17
3439a