Case IH AFX8010 Repair Manual page 1181

17. Place thrust bearing race (washer) (1) over shaft
against retaining ring. Place bearing (2) side of
thrust bearing on washer. Install ring clutch lube
seal on gear in groove on spline side (See art for
step 28). Lube the seal. Place gear assembly on
shaft, spline into clutch stack. Remove wedge pins.
Slide needle roller bearing (3), inner ring (4), and
another needle bearing (3) over shaft and press
down into gear (5) hub. Assemble thrust bearing
(7)(smooth side toward gear), thrust bearing race
(washer) (6), and retaining ring (8) (narrow side up)
onto shaft. Be sure retaining ring seats fully into
groove. Press cone (9) onto shaft end using driver.
Check to see if cone is fully seated.
18. Dab seal grooves with petroleum jelly. Apply large
seal and small seal (1) into indicated grooves on
brake end of shaft. Make sure seals (1) are not
twisted and are fully seated into grooves.
19.
Place plate (1) on top of can, flat side up. Put a
friction disk (2), plate (3), and another friction disk
(2) over shaft. Carefully assemble piston (4) over
shaft. Piston must be aligned over dowel pins and
through discs and plates. When in place the ear
on the middle plate will be held when pressing on
top of the piston. Place return spring (5) over shaft,
fingers up. Assemble ring (6) over shaft with the
lip down and inserted in the spring fingers. Using
the compressor tool, compress return spring (5)
and ring (6). Install retaining ring (7) on shaft. Be
sure retaining ring is fully seated before releasing
press. Assemble bearing cone (8) onto brake end
of shaft using a driver. Check to be sure bearing
is fully seated.
20. Sub-assemble Rotor CVT and CVT Drive Motor
Gear. Press cones (2) onto shaft (1) using the
appropriate driver. Check to see each cone is fully
seated. Press needle bearing (3) assembly into
shaft using driver. Must be flush with end of shaft.
POWER TRAIN - POWER COUPLING Fixed coupling
9679 1 27/05/2004
C.10.B / 15
17
10035843A5
18
10035847A5
19
10035846A5
20
10035848A5