Case IH AFX8010 Repair Manual page 1580

Command valve - Overhaul (D.14.C.12 - F.10.A.40)
AFX8010
•
NOTE: The solenoid valve can be replaced without removing the motor from the C-frame.
1. Turn the wheel to the steering stop to gain access
to the valve.
CAUTION
46-77A - Before you do service under the machine, put
the machine on a level surface, engage the parking
brake and stop the engine. Put blocks at the front and
rear of the tires. Failure to follow these instructions
can cause injury.
2. Release the pressure in the supply circuit.
3. Disconnect the drain line at the tank level to avoid
siphoning.
4. Disconnect the electrical connection.
5.
Remove the two capscrews (2) and cover (1).
6. Remove the Hex nut (5), magnetic winding (4) and
cartridge valve (3).
7. Make sure new cartridge valve is clean. Lubricate
O-rings with hydraulic fluid. Install new cartridge
valve (3) and torque to 24 - 30 Nm (17.8 - 22.2 lb ft).
8. Install new magnetic winding (4) and Hex nut (5).
Torque nut to 2.7 - 3.3 Nm (2.0 - 2.4 lb ft) .
9. Re-clamp electrical leads and reconnect the
electrical connection.
10. Reconnect the drain line and pressurize the supply
line.
TRAVELLING - 2WD-4WD SYSTEM Hydraulic
20042888
9688 1 27/05/2004
D.14.C / 20
1