4.
The plate on the input shaft side will remove from its
gasket fairly easily.
5.
The cover (1) on the output shaft side will be sealed
tight to the housing because of its O ring seal. To
remove the bearing in the cover (1) use a slide
hammer or small pry bar and work your way around
the bearing evenly.
6.
With both covers off remove the snap ring (1) from
the center shaft (2) on the output shaft side.
7.
Remove the bearing (1) behind the snap ring using
a set of pullers.
CROP PROCESSING - FEEDING Feeder housing
9712 1 27/05/2004
K.25.E / 28
4
10034613
5
10034608A5
6
10034614A5
7
10034616A5