Case IH AFX8010 Repair Manual page 1245

8. Install retaining ring (1).
9.
Install the two springs and two balls (3) and at the
same time install selector ring (2). Do not to lose the
balls. Install needle bearings (1).
10. Install gear (1). Install washer (2).
11. Heat bearing (4) to 80 °C ( 176 °F ) and install it
on the input shaft. Install washer (3). Install new
lock-washer (2). Install nut (1) using tool 380001074
and tighten to a torque of 150 - 170 Nm ( 111 -
125 lb ft ). Secure nut (1) by bending a lip of the
lock-washer in one of the notches of the nut.
POWER TRAIN - TRANSMISSION Mechanical
9680 1 27/05/2004
C.20.B / 55
8
3410a
9
3408a
10
3413a
11
3406a