Table of Contents
Advertisement
BODY AND STRUCTURE - SAFETY SECURITY ACCESSORIES Safety
A.
If continuity is found, the short to ground is in the main frame (MF) harness between connector X024 and
connector X019 J2-6 wire 452 white. Locate the short and repair.
B.
If no continuity is found, the short to ground is in the straw hood front (SW) harness between connector
X024 and connector X071 wire 452 white. Locate the short and repair.
8.
Use a multimeter to check for continuity between connector X248 pin 1 (black wire) and chassis ground. Flex
the harness while making this check.
A.
If no continuity to ground is found, continue with Step 9.
B.
If there is continuity to ground, the circuit is functional. Continue with Step 10.
9.
Disconnect connector X071. Use a multimeter to check for continuity between the straw hood front (SW)
harness end of connector X071 pin 26 and chassis ground.
A.
If there is continuity to ground, there is an open circuit in the straw hood rear (SH) harness between
connector X248 and connector X071 wire 455 black or 478 black. Locate the open and repair.
B.
If there is no continuity to ground, there is an open circuit in the straw hood front (SW) harness between
connector X071 and rear frame ground #1 wire 478 black. Locate the open and repair.
10.
Visually inspect the harness and connectors for damage, bent or dislocated pins, corroded terminals or
broken wires.
A.
If no damage is found, erase the fault code and continue operation.
9703 1 27/05/2004
E.50.B / 4
Advertisement
Chapters
Table of Contents
Troubleshooting
