Case IH AFX8010 Repair Manual page 1552

8. Increase force on bearing to 170,000 N (38,220
lb). Use a feeler gauge to measure the distance
between top of the split ring and the shaft spline.
Reduce force to 20,000 N (4,500 lb) and remove
split rings. Increase force to 170,000 N (38,220
lb). Install new split rings that are closest to the
measured distance. Release the force and remove
the split ring assembly hood tool (1). Insure the
gaps between the split rings are the same on each
side of the shaft.
9. Install thrust washer (1) over split rings, make sure
the thrust washer is pressed securely against the
bearing.
10. Use a torque wrench on nut (2) of special tool
(Rotational torque tool) (1) to check the final
rotational torque of the bearing support assembly.
The torque should be within 49 - 91 Nm (36 - 67 lb
ft). If the torque is correct then continue assembly.
If it is not correct then readjust the bearing support
to obtain correct torque.
11. Re-assemble the distributor valve (1) and springs
(2) by lubricating the grooves in the valve cover.
Install the O-rings (4) in the valve cover. Install the
backup rings (3) in the valve cover.
TRAVELLING - REAR AXLE
9687 1 27/05/2004
D.12.A / 36
8
20042882
9
20042883
10
20042884
11
20042863