Table of Contents
Advertisement
6.
Disconnect connector X081 and connector X007. Use a multimeter to check for continuity between connector
X081 pin 2 and connector X007 pin 17.
A.
If continuity is found, continue with Step 7.
B.
If no continuity is found, there is an open circuit in the feeder (FE) harness between connector X081 pin
C and connector X007 pin 17 wire 741 yellow. Locate the open and repair.
7.
Carefully disconnect connector X020 from the bottom of CCM1 module. Use a multimeter to check for
continuity between connector X007 pin 17 and connector X020 pin J3-17.
A.
If continuity is found, the open is in the sensor. Replace the sensor.
B.
If no continuity is found, there is an open circuit in the front frame (FF) harness between connector X007
pin 17 and connector X020 pin J3-17 wire 741 yellow. Locate the open and repair.
8.
Visually inspect the harness and connectors for damage, bent or dislocated pins, corroded terminals or
broken wires.
A.
If no damage is found, erase the fault code and continue operation.
TOOL POSITIONING - LEVELLING
9708 1 27/05/2004
G.30.A / 12
Advertisement
Chapters
Table of Contents
Troubleshooting
