Case IH AFX8010 Repair Manual page 1183

24. Unload Clutch Cover Assembly. Place bearing cup
(3) onto upper shaft. Measure height of cup above
cover (1) mounting surface. Measure depth of cup
seating surface relative to cover mounting flange.
Calculate required thickness of shims (2) to give a
rolling torque of 0.2 - 1.2 Nm (2 - 11 lb in). Press
required shims (2) and bearing cup (3) into cover (1)
using driver. Check to be sure cup is fully seated.
25. Rotor CVT and CVT Drive Motor (Variator)
Assembly. Remove and set aside the O-ring type
seal from end of variator assembly (2) to prevent
damage. Using a 12 mm wrench remove the two
small bolts (1) retaining the bearing flange (2) to
assembly and set them aside. Carefully separate
bearing flange (2) from rest of variator assembly.
Clean the mating surfaces of the flange and the
variator assembly.
NOTE: Use caution there are 8 springs (3) trapped in the
assembly by this part and they must be retained.
26. Place the cup (3) part of the bearing onto rotor drive
gear assembly. Measure the height of cup above
variator mounting surface (1). Measure the depth
of cup seating surface relative to variator mounting
flange. Calculate required thickness of shims (2) to
give the desired rolling torque of 0.2 - 1.5 Nm (2 -
13 lb in). Press required shims (2) and bearing cup
(3) into variator mounting flange (1) using a driver.
Check to be sure cup is fully seated.
27. Place O-ring (1) in groove on inner face of the
Unload Clutch mounting flange (2) and dab with
Petroleum jelly to hold in place.
POWER TRAIN - POWER COUPLING Fixed coupling
9679 1 27/05/2004
C.10.B / 17
24
10035853A5
25
10035862A5
26
10035856A5
27
20035857A5