Case IH AFX8010 Repair Manual page 1223

9. Connect the half shaft drive axles (1) to both sides
of the transmission. Half-shaft - Install (D.10.A.43
- F.10.A.15)
10.
Install the hydrostatic motor (1) into the transmission
(Apply a light coat of grease to the splines) and
connect the lines (2) if they were removed. Tighten
the motor bolts (3). Torque the motor bolts to 258 -
280 Nm (190 - 206 lb ft)
11. Install the hydraulic hose routing clamps with four
bolts (1).
12. Instal the shield bracket and shield (1) back onto
the machine. Bleed the service brakes. SERVICE
BRAKE Hydraulic - Bleed (D.30.C - F.35.A.25).
Check all lines are secure and tight. Remove the
blocks or wheel chocks from the unit.
IMPORTANT: Be sure to check the fluid level of
transmission fluid before operation, failure to do so could
result in transmission failure.
POWER TRAIN - TRANSMISSION Mechanical
9680 1 27/05/2004
C.20.B / 33
8
3194a
9
3251a
10
40034846A5
11
40034844A5