Support - Install (G.20.A.77 - F.10.A.15) - Case IH AFX8010 Repair Manual

Support - Install (G.20.A.77 - F.10.A.15)

AFX8010
Prior operation: TILTING - Remove (G.20.A - F.10.A.10)
1. Lift the face plate into position and insert the pin (1).
Secure the pin with the bolt and washer (2). Repeat
on other side of feeder.
Insert the carriage bolts and loosely install the
washers and nuts (3).
Refer to TILTING - Check (G.20.A - F.45.A.10) to
set the tilt angle based on the combine tire size.
Torque the nuts (3) to 555 - 620 Nm (408 - 460 lb
ft) .
2. Disconnect the upper hose (1) from the hydraulic
cylinder and install the cylinder on the face plate.
Reconnect the hydraulic hose. Insert the pin, 2, and
bracket, 3, and bolts. Install the pin (4). Hold in
place with the bracket and bolt (5). Set the hydraulic
coupling and electrical connector on their mounts
(6) on the face plate.
TOOL POSITIONING - TILTING
9707 1 27/05/2004
G.20.A / 5
1
40032074B5
2
40032072A5